Midmark M7 SpeedClave Sterilizer - Refurbished

Midmark M7 SpeedClave Sterilizer - Refurbished

$1,350

or
Call 804-495-0770

Description

Midmark M7 SpeedClave Sterilizer Refurbished

The Midmark M7 SpeedClave Sterilizer (#M7-020) is in excellent condition and certified to proper operating specifications, The M7 SpeedClave is an effective, manual autoclave for sterilizing both wrapped and unwrapped instruments, linen packs, and glassware. It is intended for use in dental settings, such as a dental office. It is the "workhorse" of sterilizers.

Warranty:

      • 6 Months - Parts and Labor
    • 6 Months - Parts and Labor
  • 6 Months - Parts and Labor
      • Self-contained steam sterilizer.
      • Efficient, economical, and dependable.
    • Self-contained steam sterilizer.
    • Efficient, economical, and dependable.
  • Self-contained steam sterilizer.
  • Efficient, economical, and dependable.
      • 7.5" (Diameter) x 15" (Depth) (19.1 cm x 38.1 cm).
      • 2.4 gallons (9 liters) usable volume.
      • 115 VAC, 60 Hz, 10 Amps Single Phase.
      • 115 VAC has 1136 watt tubular immersion heater.
      • A separate (dedicated) circuit is recommended for this sterilizer.
    • 7.5" (Diameter) x 15" (Depth) (19.1 cm x 38.1 cm).
    • 2.4 gallons (9 liters) usable volume.
    • 115 VAC, 60 Hz, 10 Amps Single Phase.
    • 115 VAC has 1136 watt tubular immersion heater.
    • A separate (dedicated) circuit is recommended for this sterilizer.
  • 7.5" (Diameter) x 15" (Depth) (19.1 cm x 38.1 cm).
  • 2.4 gallons (9 liters) usable volume.
  • 115 VAC, 60 Hz, 10 Amps Single Phase.
  • 115 VAC has 1136 watt tubular immersion heater.
  • A separate (dedicated) circuit is recommended for this sterilizer.

Overall Length

Overall Width

Overall Height

Weight

19" (48.3 cm) with plug

14" (35.6 cm)

13" (33 cm)

 30 lb (13.6 kg)

Specifications

ManufacturerMidmark
ConditionRefurbished
Overall LengthOverall Width | Overall Height | Weight
19" (48.3 cm) with plug14" (35.6 cm) | 13" (33 cm) | 30 lb (13.6 kg)
Safety DoorAutomatically seals when pressurized and will not allow the operator to open the door until the chamber is safely depressurized
Temperature RegulatorAllows the operator to preset the temperature at a desired setting between 250 and 270 °F (121 and 132 °C). This control, acting as a thermostat, cycles the heating element on and off
Temperature GaugeIndicates the temperature inside the chamber. The gauge is graduated in two-degree increments from 80 to 270 °F (26.7 to 132 °C)
Low Water Cut-Out SwitchPrevents "dry burning." The M7 will only operate when there is enough water present, which prolongs the life of the heating element. A pilot light is on when the heater is on and cycles on and off during normal operation
Cycle TimerRegulates sterilization time from 0 to 30 minutes and automatically turns the M7 off when the sterilization cycle is complete. This prevents over-sterilization, thus extending the service life of your instruments
Front DrainingMakes the M7 easy to clean and maintain
Counter top Area16.5" x 14" (410 mm x 345 mm)
Chamber Safety ValveSet at 31 PSI (214 kPa)
(2) Large5.62" (W) x 12" (L) x 0.88" (D) (14.3 cm x 30.5 cm x 2.2 cm)
(1) Small4.12" (W) x 12" (L) x 0.88" (D) (10.5 cm x 30.5 cm x 2.2 cm)
Weight30 lb (13.6 kg)
Water Reservoir Capacity1.31 gallons (4.9 liters)

Documents